Guide to this Manual
0
Version
1
Copyright 1995 SPEA
2
Registered Trademarks
3
FCC Compliance
4
Installing the Software from the SPEA Media-Gallery CD
5
Important Note
6
Quick Installation
7
Windows Driver - Quick Installation
9
[$%f%General Information
11
Guide to this Manual
12
Symbols and Conventions
14
Delivery Scope Checklist
15
SPEA Superdisk Format
16
Last-Minute Changes - README file
18
Warranty
19
Support
21
Company Address
23
[$%f%Part 1 - Introduction
25
Graphics Board Features
26
Software for your Board
27
[$%f%Part 2 - Hardware Installation
11
Graphics Card Installation
30
Monitor Compatibility
32
If you're using COM 4
33
Typical System Configuration
34
Preparing your Computer
35
[$%n%VLBPCI2$Installing the PCI-Board   Installing the VLB-Board%Installing the SPEA Board
36
Additional Instructions
37
After Installing the SPEA Board
38
[$%f%Part 3 - Software Installation and Configuration
40
Windows 3.1x (BigWin Driver)
41
SPEA V7SETUP
43
SPEA WinTools
45
SPEAenergy (DPMS)
46
[$%n%BIG2$%SPEAview
47
Windows NT (BigWinNT Driver)
48
AutoCAD 11 & 12 - AutoCAD for Windows
50
Aquila ADI Driver 4.2 Features
51
Font File for AutoCAD 11/12 and AutoShade
52
AutoCAD Rel. 11 - Protected Mode Driver
54
AutoCAD Rel. 12 - Protected Mode Driver
56
Configuring the Aquila Driver
57
Special Aquila Driver Features
58
AutoShade 2.1
60
3D Studio 1.0
61
3D Studio 2.0
62
MS-Flight Simulator 5.0
63
MicroStation 4.0x & 5.0
65
OS/2 2.1 & 2.11 (SPEA BigBlue Driver)
66
[$%f%Appendix A - Utilities
68
SPEAtune - Monitor / Graphics Board Tuning
69
Using SPEAtune
70
SMODE.EXE - Setting the Video Mode for DOS Applications
71
VESA Modes
73
V7HFREQ - Higher Refresh Rates under DOS
74
S3TEST.EXE
76
Using more than one Board
77
[$%f%Appendix B - Technical Details
11
Technical Data
80
V7-MIRAGE P-32 (PCI) Jumpers
81
V7-MIRAGE P-32 (VL) Jumpers
82
Memory Addresses of the V7-MIRAGE P-32
83
Video Modes
85
VGA Output Connector
87
[$%f%Appendix C - Troubleshooting
11
General Considerations
90
Commonly Asked Questions
91