Specific configuration for OS2

SNMP Configuration:

To setup SNMP service proceed, in the following way:

• define the SysContact and SysLocation values and the name of the host system;
• define the authorized community names for access to the SNMP agent (for OS/2 2.x, encrypt the names using the MAKE_PW utility) ;
• define the IP address and host system name in the \tcpip\etc\hosts file (for OS/2 WARP Connect: \mptn\etc\hosts ).
  To set these parameters perfectly, use the IBM TCP/IP configuration utility (TCPCFG). For more information refer to your TCP/IP documentation.
  Verify that there is an entry in the tcpip/etc/services (for OS/2 WARP Connect: \mptn\etc\services ) file to set the port number used to send traps.
  Add this line if it is not present: snmp-trap 162/udp

Serial Port Configuration for UM-Agent

To connect the UPS to your system via the serial port (RS232 link) the CONFIG.SYS file on your system must contain the following items:

• for OS2 2.x
  device = C:\os2\com.sys (assuming that the system is installed on disk C:).
• for OS2 WARP
  device = C:\os2\boot\com.sys (assuming that the system is installed on disk C:).