ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
   ³                      Installation for Windows 95                       ³
   ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ

   A. Installation:

      1. Plug Winbond W89C840 card into one of the PCI slots of your PC.

      2. Turn power on then boot from Windows 95.

      3. If Windows 95 prompts PCI Ethernet Controller in New Hardware Found
         dialog box, then please follow below steps to install driver :

         1) Select "Driver from disk provided by hardware manufacturer" from
            New Hardware Found dialog box, then click OK button.

         2) Insert this driver diskette into drive A:, type the path
            A:\WIN95 and click the 'OK' button.

         3) When the 'Winbond W89C840 PCI Ethernet Adapter' dialog box
            appears, press <Enter>.

         4) Follow screen instructions to complete the process.

      4. Restart your computer.


   B. Parameters

      1. BurstLen     = 32 dwords
         Burst Length defines the maximum number of long words that can be
         transferred within one PCI burst transaction.
         The reasonable values are "1 dword", "2 dwords", "4 dwords",
         "8 dwords", "16 dwords" and "32 dwords".

      2. CacheAlign   = 32 dwords
         Cache Alignment defines the address boundary for data burst.
         The reasonable values are "8 dwords", "16 dwords" and "32 dwords".

      3. Threshold    = full packet
         This value decides the transmit threshold level of the transmit FIFO.
         Transmission will start immediately after the transmit FIFO has
         reached the threshold level or full pkt has been transferred to the
         transmit FIFO if the frame length is less than the transmit threshold
         level.
                       TxThreshold         Transmit Threshold Level
                          00H                     full pkt
                          01H                     16 bytes
                          02H                     32 bytes
                          --                      --
                          7FH                      2032 bytes"

      4. LineSpeed    = AutoDetect
         This adapter can be operationed in 10M or 100M Mbps.
         The reasonable values are AutoDetect(auto detect line speed by the
         driver), 10M(set the line speed is 10M) and 100M(set the line speed
         is 100M).

      5. FullDuplex   = AutoDetect
         This adapter can be in half or full duplex mode. In half duplex mode,
         the W89C840 can only either transmit or receive. In full duplex mode,
         the W89C840 can transmit and receive at the same time.
         The reasonable values are AutoDetect(auto detect full duplex function
         by the driver), Disable(disable full duplex), and Enable(enable full
         duplex).

      6. Nway  = On
         The parameter 'Nway' is used to disable or enable the
         autonegotiation function. The default value of nway is on. The
         reasonable values are OFF(disable the nway function) and ON(enable
         the nway function).