| From: | Jim Spratt |
| Date: | 9 May 2001 at 18:27:59 |
| Subject: | Re: Blizzard 1260 + SCSIKit IV |
Hello Bob
On 09-May-01, you wrote:
> Hello again all,
>
> More help needed I'm afraid.
>
> Yesterday I installed a new 1260 + SCSIKit IV although the SCSI output was
> not connected to any devices, and all worked fine. Today I got a suitable
> cable to connect my scsi bits but they are not seen apparently. In case it
> was a termination problem I connected just to the ZIP drive and tried this
> both terminated and unterminated. Same difference; zilch. The connector is
> fitted to the DMA socket with the red line closest to the Simms holder. Is
> this correct? Do I need some kind of mount command or have I missed
> something else which is extremely obvious to other people?
Is unitcontrol seeing the Zip Drive, because if not the cables faulty I'm
afraid - you'll also need to set up a mountlist to use a CD-ROM, but worry
about l8r...
> Any help gratefully accepted.
See unitcontrol sent privately for my config...
> Regards,
Regards
jimspratt@imaga5.freeserve.co.uk or jimspratt@madasafish.com
ICQ No: 96062989 || PGP Public Key available on request ||
Powered BY A1200 030/50MHz/18Mb Ram/340Mb HD/56K Modem/SCSI Zip Drive/CD-ROM
I have made this letter longer than usual because I lack the time to
make it shorter.
-- Blaise Pascal
Quote carefully and read all ADMIN:README mails
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/