| From: | Bob Rickman |
| Date: | 10 May 2001 at 11:58:43 |
| Subject: | Re: Blizzard 1260 + SCSIKit IV |
This is a reply to a message from Alan Buxey.
Subject: Re: [amigactive] Re: Blizzard 1260 + SCSIKit IV:
Hi Alan,
On 10-May-01, Alan Buxey wrote:
> BUS contention or incorrect termination/cable config. I've seen this with
> a SCSI scanner plugged into a SCSI-II chain. do you have 2 different
> connectors on back of the scanner (eg 50-way centronics and 25-way SCSI ?)
> if so, try the other connector...and put the scanner at the end of the
> chain
I already tried using scsi controller direct to a Zip drive only, in both
terminated and unterminated state. Same results. On advice of KDH who were
the suppliers I checked version 1230scsi.device in a shell, both with and
without ram on board. Answer was "File:1230scsi.device object not found".
They believe the controller itself is at fault, and are sending me another,
tested board, asking me to return the defective one only after receipt and
satisfactory operation of new one. Better than average customer service in
my experience.
Hoping for the best.
Thanks to all who responded.
Regards,
Quote carefully and read all ADMIN:README mails
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/