5.1 Encryption

Introduction

By using encryption, communication between the wireless clients and your Thomson Gateway is protected by a passphrase. Only clients which use the correct network name (SSID) and passphrase can connect to your network.

Encryption methods

During the years a number of encryption types have been developed. The list below gives you an overview of the supported encryption types ordered by security level, you will find the highest level of security at the top of the list:

<

WPA-PSK Encryption:
The wireless data is being encrypted with a user-defined key. Wireless clients must be configured with this key before they can connect to the Thomson Gateway.

<

WEP Encryption:
The first encryption type used for wireless connections. Like WPA-PSK it uses a user-defined key, but WEP has been proven to have some security issues. We strongly recommend you to use WPA-PSK instead.

Configuring the wireless encryption

Proceed as follows:

1

Open the Thomson Gateway Web Interface.

2

On the left menu, click Home Network.

3

Under Wireless, click your access point.

Your access point will be listed in the following format: “WLAN:<Network Name> (<Actual Speed>)”. For example, WLAN: Thomson83C7C7 (54Mbps).

4

The Wireless Access Point page appears.

5

In the Navigation Bar, click Configure.

6

Under Security, you can change the Encryption. If you want to use:

 

4

WEP Encryption, continue with Configuring WEP Encryption.

 

4

WPA-PSK Encryption, continue with Configuring WPA-PSK Encryption.