a:\win95\readme.txt                     20-AUG-1996

The following step should be taken in order to use the 
Digital EtherWORKS Turbo PCI 10 in a system running
Windows 95:

1. Before inserting the card into your system boot Windows 95.

*******************************************************************
   If the adapter was inserted in the system and Windows 95 was 
   booted after the DE450 adapter was installed in the system, 
   please do the following:

     - From within Windows 95 double click on "My Computer",
        followed by "Control Panel", then "Network".

     - Under the heading "The following network components are
        installed", check to see if there is a line which says
        "PCI Fast Ethernet DECChip 21041 based adapter." If this
        line exist, click on it and then click on "Remove". 

     - Select "OK" to exit from the network setup window.

     - Proceed with steps 2 through 8.

*******************************************************************

2. Insert this driver disk into the floppy drive. From the
   "Start" menu of Windows 95 select "Run". Next to where it
   "Open:" appears in the dialog box, type "A:\SETUP". Click 
   on "OK" and the EZWORKS installation program will start.

3. Under "Select a Network Operating System" click on the
   "Windows 95" line.

4. Click on the "Install" button in order to copy all the
   necessary files onto the system.

5. Exit EZWORKS by clicking on "File" in the menu bar and then
   "Exit".

6. Shutdown Windows 95 and power off the computer.

7. Insert the network adapter into the system and connect the 
   network cable to it.

8. Power the system back on and boot Windows 95. Windows 95 
   will automatically detect the card and start the drivers. 
   Follow any instructions that Windows 95 displays to complete
   the installation process. Reboot if requested to do so by
   Windows 95.