0	Measure the point coordinates\nCoordinates of the Point\n\n
1	Measure the distance between two points\nDistance\n\n
2	Measure the angle for three given points\nAngle\n\n
3	Measure the area\nArea\n\n
4	Create hatch\nPath Hatching\n\n
100	Move one step back on the current step\nOne Step Back\n\n
101	Finish the current measurement\nFinish\n\n
102	Join the endpoints of the entity\nClose\n\n
103	Move one step back on the current entity\nOne Step Back\n\n
104	Change the select mode\nBy Entity\n\n
105	Length of the single entity\nSingle Entity\n\n
106	Default units\nUnit:Default\n\n
107	Decimal inches unit\nUnit:Dec Inch\n\n
108	Fractional inches unit\nUnit:Fract Inch\n\n
109	Decimal feet unit\nUnit:Dec Feet\n\n
110	Fractional feet unit\nUnit:Fract Feet\n\n
111	Decimal Feet-inches unit\nUnit:Dec Ft-In\n\n
112	Fractional Feet-inches unit\nUnit:Fract Ft-In\n\n
113	Decimal mm unit\nUnit:Dec mm\n\n
114	Decimal meter unit\nUnit:Dec m\n\n
300	\nHatch
400	Define the point
401	Define the start point of the angle
402	Define the middle point of the angle
403	Define the end point of the angle
404	Define the first entity
405	Define the next entity
406	Define the vertex of the hatch/area boundary
407	Define the graphic of the hatch/area boundary
408	Define the start point(use snap mode)on the sum path
409	Define the next point or the graphic on the sum path
410	Define point of graphic(press'V')or graphic for counting off only
898	A currently selected entity has lost connections to its dimensions. We recommend deleting these dimensions and re-doing them.
899	Failed because selection contains graphics which are read only.
900	Cannot continue hatch path "By Entity" as this entity has no physical path.

Try again or deselect "By Entity" and use snaps to define the path.
901	Intersection is not found.
902	Cannot continue measurement.

Try again or use the local menu.
1001	WORLD COORDINATES:
\n
1002	PAPER COORDINATES:
\n
1003	  Angle = 
1004	  Area = 
1005	 Square 
1006	  Dist = 
1007	    DeltaX = 
1008	    DeltaY = 
1009	    DeltaZ = 
1010	  Correspond to the first
\n  and last points:
\n
1011	    Angle(with 0X)=
1012	  For last segment:
\n  
1030	  Dist = 
1031	  Ang = 
1032	  Ang1 = 
3000	View\nMeasurement\nCoordinates\n&Coordinates of the Point
3001	View\nMeasurement\nDistance\n&Distance
3002	View\nMeasurement\nAngle\n&Angle
3003	View\nMeasurement\nArea\nA&rea
3004	Insert\nHatch\nPath &Hatching
29821	in
29822	ft
29823	mm
29824	m