README.TXT                          	September 8, 1998

Diskeeper[R] Lite for Windows NT[R] V1.1.174a -- x86 Platform

This text file provides information you should know about this 
version of Diskeeper Lite.


IMPORTANT NOTE
==============

Executive Software recommends that you install Service Pack 3
or higher on your computer prior to running Diskeeper Lite.
Diskeeper Lite is only supported on laptop or notebook computers 
running Service Pack 2 or higher for Windows NT 4.0.


KNOWN INCOMPATIBILITIES IN THIS RELEASE
=======================================

1.  Diskeeper Lite for Windows NT is not compatible with systems 
    using the DPT Smart Cache III controller, unless Service 
    Pack 1 or higher for Windows NT 4.0  has been installed.  Do 
    not run Diskeeper Lite on systems using the DPT Smart Cache 
    III controller  until you install Service Pack 1 or higher on 
    your Windows NT system.


PLATFORMS AND OPERATING SYSTEM VERSIONS SUPPORTED
=================================================

This version of Diskeeper Lite is supported on Intel x86 
platforms running Windows NT 4.0 builds 1381 and higher. 
It is not supported on Windows NT 5.0. 


REQUIRED PRIVILEGES
===================

You must have Administrator privileges to install and
operate Diskeeper Lite.


INSTALLING DISKEEPER LITE
=========================

Follow these steps to install Diskeeper Lite:

1.  From Windows NT Explorer or File Manager, double click on
    SETUP.EXE in the directory where this README.TXT file resides.

2.  Read the information displayed in the Setup Installation 
    Wizard boxes and click the "Next" button as appropriate.

3.  In the "Choose Destination Location" dialog box, either 
    accept the default installation location, or click the 
    "Browse" button to specify a different disk and/or 
    directory.  If you specify a directory that does not exist, 
    the setup program will create it for you.  Click the 
    "Next" button after specifying a disk and directory, or to 
    accept the default installation location.

4.  After a short period of copying files, the installation is 
    complete.


UNINSTALLING DISKEEPER LITE
===========================

Follow these steps to remove Diskeeper Lite from your computer:

1.  From Control Panel, double click "Add/Remove Programs".

2.  Click the "Install/Uninstall" tab.

3.  Highlight "Diskeeper Lite".

4.  Click the "Add/Remove" button.  This removes the Diskeeper 
    Lite program files from your computer.



(c) Copyright 1997, 1998 Executive Software International, Inc.  
    All rights reserved.

Diskeeper and Executive Software are registered trademarks owned 
by Executive Software International, Inc.

Windows NT is a registered trademark owned by Microsoft Corporation.

All other trademarks are the property of their respective owners.