could not open /dev/kbd to get keyboard type US keyboard assumed
could not get keyboard type US keyboard assumed
Subject: mod for FT-10, here it is
From: jospav@eworld.com (Jospav)


Yaesu FT-10 Extended Transmit Mod for 140-174MHz use.
 
 
 1. Remove antenna and battery.
 2. Locate the Ni-Cd battery sticker on the back of the radio chassis.
    Pry up the corner of the sticker and peel it off carefully.
 3. Remove the two screws located under the sticker. These retain the keypad.
 4. Slowly lift off the keypad. Use care not to dislodge the gasket.
 5. Locate and unsolder the 0 ohm chip resistor at location "M" (see
    diagram below).
 6. Re-install keypad with two screws. Be sure gasket is properly seated.
 7. Replace the Ni-Cd sticker if desired. Reattach battery and antenna.
 8. Press down and hold the Top-Notch and Lamp button while turning the
    radio on.
 
   | knob |
 +---------------------+
 |  +---------------+  |
 |  |  LCD Display  |  |
 |  |               |  |
 |  +---------------+  |
 |  -----------------  |
 |  -----------------  |
 |  -----------------  |
 | (on/off) ---------  |
 |                     |
 |  +---------------+  |
 |  |    Ribbon     |  |
 |  |    Cable      |  |
 |  |    ||||||     |  |
 |  |  o         o  |  |
 |  |         ::    |  |
 |  |           #:  |  |
 |  +---------------+  |
 +---------------------+
 
 # = Location "M", chip resistor to remove
 
 
 If memory serves me, the board actually has an "M" near the correct
resistor.