This Quick installation is for experienced users only! Other readers should take the time to read the manual.
Make a backup copy of the disks supplied with the board.
1. Check that your monitor and system configuration support the SPEA graphics card (e.g. correct bus type and version).
2. Disconnect your computer from the mains power and peripheral equipment.
3. If your system main board incorporates a video adapter deactivate it.
4. Change the jumper settings if required. The jumper settings on the board can normally remain unchanged. There are however conditions (e.g. if combining boards in a system) when changes should or must be made. Read the relevant section in the README file to be sure.
5. Install your SPEA graphics board in a free extension slot.
6. Reassemble your PC, connect peripheral equipment and reconnect the power cable.
7. Switch on your monitor first, then the computer.
8. At the DOS prompt insert the SPEA disk 'Utilities' and start the software installation with:
