Enter the time-out value (in seconds) to use when establishing connections. Valid range is 1 to 255; 0 means an infinite wait.
Enter the time-out value (in seconds) to use when transfering data over the Control Connection. Valid range is 1 to 255; 0 means an infinite wait.
Enter the time-out value (in seconds) to use when transfering data over the Data Connection. Valid range is 1 to 255; 0 means an infinite wait.
Set the amount of memory to allocate to the MacTCP driver.
The more you give, the faster it transfers.
Set the amount of memory to allocate to FTPack.
Check this item to send a TYPE command before each Binary or MacBinary transfer. It slows down transfers of folders but it prevents conflicts with particular servers.
Check this item to send a PORT command before opening each Data Connection. It may slightly slow down some processes but it prevents conflicts with particular servers.
Enter the Port number to use when opening the Control Connection; the default value is 21. Change it only when connecting to non-standard FTP Servers.
