home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
BibleWare
/
BibWare.bin
/
bibstudy
/
gospel22.exe
/
GOSPEL.DOC
< prev
next >
Wrap
Text File
|
1996-01-13
|
14KB
|
290 lines
GOSPEL PARALLELS (tm)
Program and features:
GOSPEL PARALLELS is for those who need a harmony of the New
Testament books of Matthew, Mark, Luke and John. The program presents
the four gospels side by side, and displays parallel passages in
seconds. Additional features include a chronological passage index,
table of parallel passages, cut and paste text, a full screen editor,
and word search capabilities.
Requirements:
There are no special hardware requirements necessary to run
GOSPEL PARALLELS, however, a hard disk GREATLY enhances the program.
Since the program is disk intensive, the faster the disk drive, the
more responsive the program will appear. If you wish to use GOSPEL
PARALLELS on your hard drive, follow these steps from the DOS prompt:
C:>MKDIR C:\GOSPEL
C:>COPY A:\*.* C:\GOSPEL
These two commands will copy all of the files from the source
diskette in drive A: to your hard drive C: in a subdirectory named
GOSPEL. Then to execute the program in the future:
C:>CHDIR C:\GOSPEL
C:>GOSPEL
Again I repeat, the above procedure is NOT necessary to run
GOSPEL PARALLELS. The program will run straight from the original
source diskette. But if you wish to see the power and speed of GOSPEL
PARALLELS, copying the program to your hard drive (as described above)
IS SUGGESTED. There is a batch file on the source diskette that will
install GOSPEL PARALLELS to your hard drive IF you wish to use it, and
performs the four above commands. The batch file is named INSTALL.BAT
and can be executed at the DOS prompt by typing: INSTALL
If your computer is NOT equipped with a hard disk drive, and you
wish to run the program from the original floppy disk, make sure that
you have a CONFIG.SYS file with a FILES= statement with at least a value
of "10". GOSPEL PARALLELS will often have 10 files open at the same
time, therefore this requirement. See your DOS manual under "FILES"
command if you need help.
Limitations:
The unregistered shareware version is as complete as we could
make it and still have it run on one 360K diskette. Since the complete
program and associated data files require over 500,000 bytes of disk
space, we had to truncate the text files in order to fit the program
on one 360K diskette for shareware distribution. The result is that
only HALF of the text to each of the 4 gospels is available with the
shareware version. The registered version of GOSPEL PARALLELS,
however, contains the COMPLETE text to all four gospels.
To start:
To start GOSPEL PARALLELS from your diskette, type at the DOS
prompt: GOSPEL then press [ENTER].
After loading itself into memory, the program will prompt the
user to press any key to continue. Once the opening title screen
disappears, the user will be looking at a screen divided into four
equal viewports. In each viewport will appear one of the four New
Testament gospels. One of the viewports will be active for scrolling,
and can be distinguished by the reverse video attributes of its
viewport (i.e., black characters on a white background - for those with
color monitors). The active viewport can also be identified by two
horizontal bars - one at the top of the viewport, and one at the
bottom. You can change the active viewport by using the TAB, SHIFT
TAB, or RIGHT and LEFT ARROW keys (see "[F1] Help" key should you ever
need help). Once a viewport is active, you can scroll the Bible text
in that viewport by using the cursor control keys. The cursor control
keys are those keys marked with UP, DOWN, LEFT and RIGHT arrows. They
also correspond to the HOME, PG UP, PG DOWN, and END keys. Make sure
that you have the NUM LOCK key OFF so that you do no execute the
numbers instead.
If you want to go to a specific Bible passage, for example
Mark 4:12, but do not wish to hold down the PG DN key, the user can
press the [G] key (short for "go to"). The user will then be
prompted for the chapter and verse to jump to.
Finding parallel passages:
To find parallel passages of a particular section in the
Gospels the user can press the [F] key (short for "find parallel").
Here is an example that will demonstrate the "find parallel"
function, and at the same time reveal the importance of comparing
scripture with scripture:
1. Highlight the book of Matthew, if it isn't highlighted
already.
2. Press the [G] key, and enter "8:11" when prompted for a
chapter and verse to "go to" within the book of Matthew.
3. In a few seconds, Matthew 8:11 will be displayed.
4. Now press the [F] key to "find parallel" passages in the
other 3 gospels. After a few seconds you will notice that
the only parallel passage to Matthew 8:11 exists in Luke 13,
verses 28 & 29 to be specific. Also notice that the
message "No parallel exists in Mark" appears to inform you
that no parallel exists in Mark, and likewise in the book of
John.
If you are an average Bible student you will probably learn
something new if you compare the two passages now displayed before you.
In both passages (Matthew and Luke) Jesus foretells the blessings and
judgments in the days when the kingdom of God is established.
What is interesting is how the two gospel authors describe the
kingdom. Matthew uses the expression "the kingdom of heaven" to
describe those days when the nations shall be blessed through
the seed of Abraham, i.e. through Jesus. Luke, on the other hand, uses
the expression "the kingdom of God". I would venture to guess that 95%
of all Christians do not realize that "the kingdom of heaven" and "the
kingdom of God" are synonymous terms.
If the user is skeptical about this new discovery concerning the
the kingdom, let us examine another feature of GOSPEL PARALLELS that
should convince us that this view is indeed the truth.
While still in the book of Matthew, with chapter 8, verse 11
displayed, press the [W] key to perform a word search on the word
"mysteries". When prompted to enter a word string to locate, enter the
word "mysteries" (exclude the quotes). The word search feature is case
INsensitive, therefore you can enter UPPERCASE or lowercase letters.
It makes no difference. After entering the word "mysteries", the
program will jump to the next passage in Matthew where "mysteries" can
be located, specifically Matthew 13:11. If you have a color monitor,
the word found will be highlighted in red. Press the [F] key to find
any parallel passages. You will find that there are two parallel
passages to Matthew 13:11 - one in Mark 4:11, and another in Luke 8:10.
Do you notice anything when you compare these three passages in
regards to "the kingdom"? Again, Matthew describes that age to come as
"the kingdom of heaven," whereas Mark and Luke use the expression "the
kingdom of God". Try finding parallels to Matthew 5:3 and 11:11 if you
would like to continue this Bible study on "the kingdom".
This little tutorial using "the kingdom" as an example shows
you how useful GOSPEL PARALLELS can be. There is nothing better when
studying the Bible than to compare scripture with scripture.
Tip: If you receive a "No parallel exists in _____" message
when searching for a parallel passage, try your search on the verse
just prior to just after the one you are viewing. For instance, if no
parallel exists for Matthew 6:8, try Matthew 6:7 or Matthew 6:9.
You are more likely to find a parallel match at the beginning of a
new Bible narrative, rather than at the middle or end of one. Some
gospel accounts are quite detailed, while others are more general.
For example, all 4 gospel writers record of Jesus' triumphal entry