╘HE SUPPORT PROGRAM ALLOWS YOU TO EDIT THE ╚AYES COMMANDS SENT TO THE MODEM WHEN THE ┬┬╙ INITIALIZES ITSELF.
╙OME OF THE COMMANDS SHOULD NOT BE CHANGED, UNLESS YOUR MODEM CAN STORE THE SETTINGS IN NON-VOLATILE MEMORY.
╫HAT FOLLOWS IS AN EXPLANATION OF THE DEFAULT SET OF COMMANDS THAT THE ─╘╩-┬┬╙ USES:
═AIN INITIALIZATION:
--------------------
┴╘┌ - ó╥ESETS MODEM.
┴╘╙7=20 - ó╘ELLS ┬┬╙ TO WAIT 20 SECONDS FOR A CARRIER BEFORE HANGING UP. ╘HIS SHOULD NOT BE CHANGED.
┴╘╓0 - ó╒SE NUMERIC RESPONSE CODES (REQUIRED FOR BAUD DETECT).
┴╘╪1 - ó╒SE BAUD RATE DETECT RESPONSE CODE SET (REQUIRED FOR 1200/2400).
┴╘╙2=3 - ó╙ETS ESCAPE SEQUENCE TO ├╘╥╠-├'S. ╘HIS WAS DONE TO PREVENT USERS FROM HANGING THEMSELVES UP WITH "+++". ╘HE ┬┬╙ WILL NOT ECHO ├╘╥╠-├'S SENT BY THE USER.
┴╘═0 - ó╦EEPS SPEAKER OFF AT ALL TIMES.
┴╘╙0=2 - ó╘ELLS ┬┬╙ TO ANSWER AFTER 2 RINGS. ╘HIS ALLOWS SOME TIME FOR THE ┬┬╙ TO CYCLED THROUGH FOR THE NEXT CALL.
╘ERMINAL INITIALIZATION:
------------------------
┴╘╙0=0 - ó╘ELLS ┬┬╙ NOT TO ANSWER PHONE IF IT RINGS.
┴╘╓1 - ó╒SE VERBOSE RESPONSE CODES.
┴╘┼1 - ó╘URNS ┴╘ COMMAND ECHO ON. ╔F YOU HAVE PROBLEMS WITH GARBAGE CHARACTERS WHEN ENTERING ┴╘ COMMANDS AT 2400 BPS, YOU MAY WANT TO TAKE THIS COMMAND OUT.
┴╘═1 - ó╘URNS SPEAKER ON DURING DIALING AND CONNECT.
┴╘╙7=45 - ó╘ELLS ┬┬╙ TO WAIT FOR 45 SECONDS FOR CARRIER WHEN DIALING OUT.
╚AYES COMMANDS MAY BE COMBINED ON ONE LINE. ╞OR EXAMPLE, INSTEAD OF SENDING AN ┴╘═1 COMMAND, THEN SENDING AN ┴╘┼1 COMMAND, THEY CAN BE COMBINED INTO ┴╘═1┼1. ╘HE AUTOCONFIGURE ROUTINE PUTS THE COMMANDS ON ONE LINE. ╔F YOUR MODEM CAN'T HANDLE THIS, SEPERATE THE COMMANDS WITH SPACES IN THE CONFIGURATION AND THE ┬┬╙ WILL SEND THEM TO THE MODEM ONE AT A TIME.
╘HE ┴╘┌ COMMAND SHOULD ALWAYS BE SENT SEPERATELY.
╔F YOU ARE HAVING PROBLEMS GETTING YOUR 2400 BPS MODEM TO ANSWER AT 2400, TRY CHANGING THE ┴╘╪1 COMMAND TO ┴╘╪4, AND MAKE SURE THE DEFAULT BAUD RATE IS 2400.
