3.2.4 DECT Setup

Introduction

The Thomson Gateway is equipped with a DECT base station allowing you to connect up to five DECT phones. Before you can start using your DECT phones, you first have to register it to your Thomson Gateway.

What you need

During the registration procedure you will be asked to enter a PIN code. You can find this PIN code on the label on the bottom of the Thomson Gateway.

Procedure

To connect your DECT phone to the Thomson Gateway base station:

1

Start the registration on the DECT phone.
For more information, consult the user documentation of your DECT phone.

2

Put the Thomson Gateway base station in registration mode.

Put the Thomson Gateway base station in registration mode

On the Thomson Gateway:

1

Shortly press the registration button () on the Thomson Gateway back panel.

2

The DECT phone prompts you that the registration was successful.